Table of Contents
Advertisement
JunosE 11.3.x Command Reference Guide N to Z
oam-pvc
Syntax
Release Information
Description
Options
Mode
110
oam-pvc [ manage ] [ loopbackFrequency ]
no oam-pvc [ manage ]
Command introduced in JunosE Release 7.1.0.
ATM VC Class Configuration mode added in JunosE Release 7.3.0.
In ATM VC Configuration mode, enables generation of F5 OAM loopback cells on an ATM
PVC and, optionally, enables F5 OAM VC integrity features that affect the operational
state of the circuit. The oam-pvc command is valid only for data PVCs configured with
aal5snap, aal5autoconfig, or aal5mux ip encapsulation; you cannot use this command
for data PVCs with other encapsulation types or for control (ILMI or signaling) PVCs. The
no version restores the default behavior, which disables F5 OAM VC integrity and restores
the default value for loopback frequency.
In ATM VC Class Configuration mode, enables generation of F5 OAM loopback cells and,
optionally, enables F5 OAM VC integrity features as part of a VC class definition that you
assign to an ATM data PVC. The no version restores the default behavior, which disables
F5 OAM VC integrity and restores the default loopback frequency, in the VC class.
manage—Enables F5 OAM VC integrity on the ATM PVC
loopbackFrequency—Number of seconds, in the range 1–600, for the router to wait
between the transmission of loopback cells during normal operation; default value is
10
ATM VC Configuration, ATM VC Class Configuration
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
