Path Ds1 Fdl - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide N to Z

path ds1 fdl

Syntax
Release Information
Description
Options
Mode
146
path pathChannel ds1 tributaryIdentifier fdl { ansi | att | all | none }
no path pathChannel ds1 tributaryIdentifier fdl [ ansi | att | all ]
Command introduced before JunosE Release 7.1.0.
Specifies the FDL standard for a DS1 signal when DS1 is configured over a channelized
SONET or SDH interface. The no version restores the default, none.
pathChannel—Number, in the range 1–2147483648, that identifies the path
tributaryIdentifier—Specifier for the tributary in the format
pathChannel { ds1 | e1 } pathPayload/tributaryGroup/tributaryNumber
pathPayload—Payload number for the path; value is 1 for SONET and in the range
1–3 for SDH
tributaryGroup—Number, in the range 1–7, that identifies the group within the path
tributaryNumber—Number of the tributary within the tributary group; the value is in
the range 1–4 if the tributary type is vt15 or tu11 and in the range 1–3 if the tributary
type is tu12
ansi—Specifies ANSI T1.403 Standard for extended superframe FDL exchange support
att—Specifies AT&T Technical Reference 54016 for extended superframe FDL exchange
support
all—Specifies both the AT&T and ANSI mode for extended superframe FDL exchange
support
none—Removes the current FDL mode settings
Controller Configuration
Copyright © 2010, Juniper Networks, Inc.