Table of Contents
Advertisement
Network and Security Manager Administration Guide
206
Figure 50: View Template Priority (DoS Highest)
Use the up and down arrows to change the template priority order. This example
continues with DoS2 having the higher priority.
Verify that the configuration values from the DoS and DoS2 templates have been
7.
applied in the device configuration:
a.
Select Network > Zone in the device navigation tree. Double-click the untrust
zone. The untrust-Predefined Zone dialog box appears.
b.
Select Screen > Denial of Service Defense and review the values applied by
the template, as shown in Figure 51 on page 206.
Although both the DoS and DoS2 templates configured threshold values for the
Source IP Based Session Limit field, the higher threshold value from DoS2
appears in the device configuration because you assigned the DoS2 template
a higher priority than the DoS template.
Figure 51: View Values from DoS and DoS2 Templates
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
