Show L2Tp Tunnel - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

show l2tp tunnel

Syntax
Release Information
Description
Options
Copyright © 2010, Juniper Networks, Inc.
show l2tp tunnel [ detail ] [ state { adminState | ifOperStatus |
failover-resync failoverResyncMode } ]
[ l2tpName | [ virtual-router vrName ] ip ipAddress [ l2tpNameNoDest ] ] [ filter ]
To display summary information:
show l2tp tunnel summary [ filter ]
Command introduced before JunosE Release 7.1.0.
failover-resync keyword and failoverResyncMode variable added in JunosE Release 9.0.0.
Displays detailed information about the configured and operational status of selected
L2TP tunnels or summary information for all L2TP tunnels.
detail—Provides complete information about the specified sessions, including the L2TP
host profile name
adminState—Displays information about tunnels only with the specified effective
administrative state
enabled—Effective administrative state is disabled
disabled—Effective administrative state is enabled
drain—Effective administrative state is drain
ifOperStatus—Displays information about tunnels only with the specified operational
state
up—Operational state is up
down—Operational state is down
lower-down— Operational state is lower down
not-present—Operational state is not-present
failoverResyncMode—Displays information about tunnels that use the specified failover
resynchronization mode:
disable—Peer failover resynchronization is disabled
failover-protocol—Uses the L2TP failover protocol method
failover-protocol-fallback-to-silent-failover—Uses the L2TP failover protocol method;
however, if the peer does not support this method, the silent failover method is used
not-configured—Uses the global failover method because peer failover
resynchronization is not configured for L2TP host profiles and AAA domain map
tunnels
silent-failover—Uses the L2TP silent failover method
Chapter 7: S Commands
981