Neighbor Allow - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide N to Z

neighbor allow

Syntax
Release Information
Description
Options
Mode
26
[ no ] neighbor peerGroupName allow accessListName
[ max-peers maxNumberDynamicPeers ]
Command introduced before JunosE Release 7.1.0.
Configures the peer group so that it accepts inbound connections from any remote
address that matches the access list. The no version removes the configuration.
peerGroupName—Name of a BGP peer group
accessListName—Name of an access list that specifies remote addresses from which
BGP connections may be accepted
maxNumberDynamicPeers—Maximum number of dynamic peers that a member of the
peer group may accept
Router Configuration
Copyright © 2010, Juniper Networks, Inc.