Set Origin - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

set origin

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
set origin atOrigin
no set origin
Command introduced before JunosE Release 7.1.0.
Sets the BGP origin of an advertised route. The no version removes the set clause from
a route map.
atOrigin—Specifies the origin from the following choices:
egp—Remote exterior gateway protocol
igp—Local interior gateway protocol
incomplete—Origin unknown
Route Map Configuration
Chapter 7: S Commands
505