Ospf Bandwidth - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide N to Z

ospf bandwidth

Syntax
Release Information
Description
Mode
116
[ no ] ospf bandwidth
Command introduced in JunosE Release 10.3.0.
Directs the router to use the bandwidth configured on an OSPF interface for OSPF
interface cost calculation. If you configure the bandwidth and then issue the no ospf
bandwidth command, the router ignores the cost that is calculated using the configured
bandwidth. The no version disables the use of the bandwidth for OSPF interface cost
calculation.
Router Configuration
Copyright © 2010, Juniper Networks, Inc.