Show Dvmrp Tunnel - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide N to Z

show dvmrp tunnel

Syntax
Release Information
Description
Options
Mode
668
show dvmrp tunnel [ detail ] [ state tunnelStatus ] [ tunnelName |
[ virtual-router vrName ] ip ipAddress [ tunnelName ] ] [ filter ]
To display summary information:
show dvmrp tunnel summary [ filter ]
Command introduced before JunosE Release 7.1.0.
Displays information about DVMRP tunnels.
detail—Shows detailed tunnel information about DVMRP tunnels
tunnelStatus—State of tunnels for which information is displayed; one of the following:
disabled—Tunnel is disabled
down—Tunnel is not operational
enabled—Tunnel is enabled
lower-down—Interface layer below the tunnel is not operational
not-present—Tunnel service module is not in slot
up—Tunnel is operational
tunnelName—Name of a tunnel for which you want to display information
vrName—Name of a virtual router for which tunnel information is displayed
ipAddress—IP address associated with tunnel
filter—See Filtering show Commands on page 4
summary—Displays summary information
Privileged Exec
Copyright © 2010, Juniper Networks, Inc.