Radius Udp-Checksum - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

radius udp-checksum

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
radius udp-checksum { enable | disable }
no radius udp-checksum
Command introduced before JunosE Release 7.1.0.
Enables or disables UDP checksum for RADIUS packets on virtual routers that you
configure for B-RAS. The no version restores the default value, enable.
enable—Specifies the feature; this is the default setting
disable—Disables the feature
Global Configuration
Chapter 6: R Commands
353