Path Ds3 T1 Clock Source - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

path ds3 t1 clock source

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
path pathChannel ds3 ds3Channel t1 t1Channel clock source
{ line | internal { module | chassis } }
no path pathChannel ds3 ds3Channel t1 t1Channel clock source
Command introduced before JunosE Release 7.1.0.
Configures the transmit clock source for a T1 channel on a DS3 signal. This command
applies to a T1 channel on a DS3 over channelized SONET interface. The no version
restores the default value, line.
pathChannel—Number, in the range 1–2147483648, that identifies the path
ds3Channel—Number, in the range 1–3, that identifies the DS3 channel
t1Channel—One or more individual T1 channels, ranges of T1 channels, or combination
of individual channels and ranges, in the range 1–28 (no spaces); for example,
3,7-15,19-13,27
line—Interface transmits data from a clock recovered from the line's receive data
stream
internal—Interface transmits data using its internal clock. You must specify one of the
following for internal clocking:
module—Internal clock is from the line module itself
chassis—Internal clock is from the configured system clock
Controller Configuration
Chapter 4: P Commands
165