Radius Ignore - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

radius ignore

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
radius ignore attributeName { enable | disable }
no radius ignore attributeName
Command introduced before JunosE Release 7.1.0.
pppoe-max-session keyword added in JunosE Release 9.3.0.
Ignores the specified attribute in RADIUS Access-Accept messages. All attributes are
disabled by default except for Framed-Ip-Netmask and Max-Clients-Per-Interface
(pppoe-max-session). The no version restores the default.
attributeName—One of the following RADIUS attributes:
atm-mbs—Mbs, VSA 26-17
atm-pcr—Pcr, VSA 26-15
atm-scr—Scr, VSA 26-16
atm-service-category—Service-Category, VSA 26-14
egress-policy-name—Egress-Policy-Name, VSA 26-11
framed-ip-netmask—Framed-Ip-Netmask, attribute 9
pppoe-max-session—Max-Clients-Per-Interface, VSA 26-143
ingress-policy-name—Ingress-Policy-Name, VSA 26-10
virtual-router—Virtual-Router, VSA 26-1
enable—Specifies the feature; this is the default setting for framed-ip-netmask and
pppoe-max-session
disable—Disables the feature; this is the default setting for all attributes except
framed-ip-netmask and pppoe-max-session
Global Configuration
Chapter 6: R Commands
323