Oam Cc - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

oam cc

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
oam cc [ segment | end-to-end ] { source | sink | both }
no oam cc
Command introduced in JunosE Release 7.1.0.
ATM VC Class Configuration mode added in JunosE Release 7.3.0.
In ATM VC Configuration mode, enables F5 OAM continuity check (CC) verification on
an ATM PVC. The oam cc command is valid only for data PVCs; you cannot use this
command for control (ILMI or signaling) PVCs. The no version restores the default
behavior, which disables F5 OAM CC verification and restores the default setting for cell
termination, end-to-end.
In ATM VC Class Configuration mode, enables F5 OAM CC verification as part of a VC
class definition that you assign to an ATM data PVC. The no version restores the default
setting for cell termination, end-to-end, in the VC class.
segment—Opens an F5 OAM CC segment cell flow
end-to-end—Opens an F5 OAM CC end-to-end cell flow
source—Enables this VC as the source point (cell generator)
sink—Enables this VC as a sink point (cell receiver)
both—Enables this VC as both a sink point and a source point
ATM VC Configuration, ATM VC Class Configuration
Chapter 3: O Commands
109