Path Ds1 Fdl String - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide N to Z

path ds1 fdl string

Syntax
Release Information
Description
Options
Mode
148
path pathChannel ds1 tributaryIdentifier fdl string { eic eicValue | fic ficValue |
lic licValue | unit unitValue | pfi pfiValue | port portValue |
generator generatorValue }
no path pathChannel ds1 tributaryIdentifier fdl string { eic | fic | lic | unit | pfi | port | generator
}
Command introduced before JunosE Release 7.1.0.
Defines an FDL message for a DS1 signal, as defined in the ANSI T1.403 specification.
This command applies to a DS1 over channelized SONET or SDH interface. Currently,
FDL strings can only be configured locally. The no version restores the default value to
the specified FDL message or to all FDL messages.
pathChannel—Number, in the range 1–2147483648, that identifies the path
tributaryIdentifier—Specifier for the tributary in the format
pathChannel { ds1 | e1 } pathPayload/tributaryGroup/tributaryNumber
pathPayload—Payload number for the path; value is 1 for SONET and in the range
1–3 for SDH
tributaryGroup—Number, in the range 1–7, that identifies the group within the path
tributaryNumber—Number of the tributary within the tributary group; the value is in
the range 1–4 if the tributary type is vt15 or tu11 and in the range 1–3 if the tributary
type is tu12
eicValue—Equipment identification code; 1–10 characters; default value is the null
value
ficValue—Frame identification code; 1–10 characters; default value is the null value
licValue—Line identification code; 1–10 characters; default value is the null value
unitValue—Unit identification code; 1–6 characters; default value is the null value.
pfiValue—Facility identification code to send in the FDL path message; 1–38 characters;
default value is the null value
portValue—Equipment port number to send in the FDL idle signal message; 1–38
characters; default value is the null value
generatorValue—Generator number to send in the FDL test signal message; 1–38
characters; default value is the null value
Controller Configuration
Copyright © 2010, Juniper Networks, Inc.