Show Ipv6 Tunnel-Route - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide N to Z

show ipv6 tunnel-route

Syntax
Release Information
Description
Options
Mode
954
show ipv6 tunnel-route [ vrf vrfName ] [ ipv6Address [ detail ] | ipv6Prefix [ detail ] ]
[ all ] [ protocol ] [ filter ]
Command introduced in JunosE Release 7.1.0.
vrf keyword and vrfName variable added in JunosE Release 7.2.0.
Displays current state of the IPv6 tunnel routing table.
vrfName—Name of the VRF
ipv6Address—IPv6 address
ipv6Prefix—Prefix of prefix list entry; in the format IPv6baseaddress / length; for example,
1::1/32
detail—Displays detailed information about the specific route
all—Displays all routes in the IPv6 tunnel routing table inserted from all protocols, not
just the best routes
protocol—The following protocols for which you want to display the best route or all
routes in the tunnel routing table; no routes are displayed if routes for the specified
protocol are not present in the tunnel routing table
NOTE: Other protocol options are available in the CLI, but they are not
applicable to the tunnel routing table.
bgp-tunnel—Displays the BGP tunnel routes in the tunnel routing table
filter—See Filtering show Commands on page 4
Privileged Exec, User Exec
Copyright © 2010, Juniper Networks, Inc.