Set Metric - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide N to Z

set metric

Syntax
Release Information
Description
Options
Mode
502
set metric [ +relValue | -relValue | absValue ]
no set metric
Command introduced before JunosE Release 7.1.0.
Modifies the metric value (for BGP, the MED) for a route that matches the route map by
applying a relative or absolute metric. The no version removes the set clause from a route
map.
NOTE: You cannot have an absolute and a relative metric within the same
route map sequence. Issuing either command overrides any previously
configured metric in the route map.
+—Specifies that the value is added to the metric for routes matching the route map;
immediately precedes the metric value with no intervening space
–—Specifies that the value is subtracted from the metric for routes matching the route
map; immediately precedes the metric value with no intervening space
relValue—Number, in the range 0–4294967295
absValue—Number, in the range 0–4294967295
Route Map Configuration
Copyright © 2010, Juniper Networks, Inc.