Neighbor Route-Map - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide N to Z

neighbor route-map

Syntax
Release Information
Description
Options
Mode
58
neighbor { ipAddress | ipv6Address | peerGroupName } route-map mapTag
{ in | out }
no neighbor { ipAddress | ipv6Address | peerGroupName } route-map [ mapTag ]
{ in | out }
Command introduced before JunosE Release 7.1.0.
ipv6Address variable added in JunosE Release 8.0.0.
Applies a route map to incoming or outgoing routes. If an outbound route map is specified,
BGP advertises only routes that match at least one section of the route map. The no
version removes a route map.
ipAddress—IP address of BGP neighbor
ipv6Address—IPv6 address of BGP neighbor
peerGroupName—Name of BGP peer group. If you specify a BGP peer group by using
the peerGroupName argument, all the members of the peer group inherit the
characteristic configured with this command, unless it is overridden for a specific peer.
mapTag—Name of the route map; a string of up to 32 alphanumeric characters
in—Applies route map to incoming routes
out—Applies route map to outgoing routes; you cannot configure a member of a peer
group to override the inherited peer group characteristic for outbound policy
Address Family Configuration, Router Configuration
Copyright © 2010, Juniper Networks, Inc.