Set Distance - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

set distance

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
set distance distance
no set distance
Command introduced before JunosE Release 7.1.0.
Configures an administrative distance to apply to routes that match the route map. The
no version removes the set clause from a route map.
NOTE: Setting a distance in a route map is useful only when it is set on a
route being installed into the routing table. Distance is used to establish
preference between routes to the same prefix to identify the best route to
that prefix. Setting distance in any other circumstance has no effect.
distance—Administrative distance in the range 0–255
Route Map Configuration
Chapter 7: S Commands
493