Path Ds1|E1 Channel-Group Snmp Trap Link-Status - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

path ds1|e1 channel-group snmp trap link-status

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
[ no ] path pathChannel { ds1 | e1 } tributaryIdentifier
channel-group channelGroupNumber snmp trap link-status
Command introduced before JunosE Release 7.1.0.
Enables SNMP link status processing on a DS1 or an E1 channel group of channelized
SONET and SDH interfaces. The no version disables SNMP link status processing on a
DS1 or an E1 channel group.
pathChannel—Number, in the range 1–2147483648, that identifies the path
tributaryIdentifier—Specifier for the tributary in the format
pathChannel { ds1 | e1 } pathPayload/tributaryGroup/tributaryNumber
pathPayload—Payload number for the path; value is 1 for SONET and in the range
1–3 for SDH
tributaryGroup—Number, in the range 1–7, that identifies the group within the path
tributaryNumber—Number of the tributary within the tributary group; the value is in
the range 1–4 if the tributary type is vt15 or tu11 and in the range 1–3 if the tributary
type is tu12
channelGroupNumber—Either a fractional T1 interface in the range 1–24 or a fractional
E1 interface in the range 1–31
Controller Configuration
Chapter 4: P Commands
137