Neighbor Timers - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide N to Z

neighbor timers

Syntax
Release Information
Description
Options
Mode
66
neighbor { ipAddress | ipv6Address | peerGroupName } timers keepaliveTime holdTime
no neighbor { ipAddress | ipv6Address | peerGroupName } timers [ keepaliveTime ]
[ holdTime ]
Command introduced before JunosE Release 7.1.0.
ipv6Address variable added in JunosE Release 8.0.0.
Sets keepalive and hold-time timers for the specified neighbor or peer group. Overrides
values set for the router with the timers bgp command. The no version restores the
default values.
ipAddress—IP address of BGP neighbor
ipv6Address—IPv6 address of BGP neighbor
peerGroupName—Name of a BGP peer group. If you specify a BGP peer group by using
the peerGroupName argument, all the members of the peer group inherit the
characteristic configured with this command, unless it is overridden for a specific peer.
keepaliveTime—Interval in seconds between keepalive messages, in the range 0–65535
seconds; default value is 30 seconds; a value of zero prevents BGP from sending
keepalive messages
holdTime—Period in seconds that BGP waits for keepalive messages before declaring
the neighbor to be unavailable, in the range 0–65535 seconds; default value is 90
seconds; a value of zero informs BGP not to expect any keepalive messages
Address Family Configuration, Router Configuration
Copyright © 2010, Juniper Networks, Inc.