Neighbor Prefix-Tree - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide N to Z

neighbor prefix-tree

Syntax
Release Information
Description
Options
Mode
54
neighbor { ipAddress | ipv6Address | peerGroupName }
prefix-tree prefixTreeName { in | out }
no neighbor { ipAddress | ipv6Address | peerGroupName }
prefix-tree [ prefixTreeName ] { in | out }
Command introduced before JunosE Release 7.1.0.
ipv6Address variable added in JunosE Release 8.0.0.
Assigns an inbound or outbound prefix tree. The no version removes the prefix tree.
ipAddress—IP address of BGP neighbor
ipv6Address—IPv6 address of BGP neighbor; valid only under the IPv4 address family
for advertising IPv4 routes over BGP IPv6 peers
peerGroupName—Name of a BGP peer group. If you specify a BGP peer group by using
the peerGroupName argument, all the members of the peer group inherit the
characteristic configured with this command, unless it is overridden for a specific peer.
prefixTreeName—Name of a BGP prefix tree
in—Assigns prefix tree to incoming routes (inbound policy)
out—Assigns prefix tree to outgoing routes (outbound policy); you cannot configure a
member of a peer group to override the inherited peer group characteristic for outbound
policy
Address Family Configuration, Router Configuration
Copyright © 2010, Juniper Networks, Inc.