Network - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

network

Syntax
Release Information
Description
Options
Copyright © 2010, Juniper Networks, Inc.
For BGP:
[ no ] network { networkNumber [ [ mask ] networkMask ] | ipv6Prefix | rtfPrefix }
[ route-map mapTag ] [ weight weight ] [ backdoor ]
For DHCP local server:
network networkAddress { networkMask | prefix }
no network [ force ]
For RIP:
[ no ] network networkAddress [ networkMask ]
Command introduced before JunosE Release 7.1.0.
rtMemNlri variable added in JunosE Release 9.0.0.
rtMemNlri variable replaced by rtfPrefix variable in JunosE Release 9.1.0.
For BGP, does one of the following:
Configures a BGP speaker with an IPv6 or IPv4 prefix originating within its AS that it
advertises to its peers if a non-BGP route to the prefix exists in the IP forwarding table.
The no version removes the prefix.
Originates a RT-MEM-NLRI route for the prefix that represents the route-target
membership NLRI. This route is advertised to all peers that have negotiated the
route-target address family. The advertisement is used by the speaker to exhibit interest
in or request routes from a specific VPN that is not configured locally. The no version
removes the prefix.
For DHCP local server, specifies IP addresses that the DHCP local server can provide
from an address pool. The no version removes the network address and mask.
For RIP, enables RIP on a specific network (not on a range of networks). If you do not
associate a network with RIP, the router cannot advertise the network in any RIP update.
The no version disables RIP on a specific network. If you do not specify a network mask,
the router applies the natural mask. Use the ip rip commands to configure RIP attributes
on the network.
networkNumber—Prefix that BGP will advertise
networkMask—Subnet mask for the network
ipv6Prefix—IPv6 prefix that BGP will advertise
rtfPrefix—Prefix representing the route-target membership NLRI (RT-MEM-NLRI), in
the format asNumber:extendedCommunity/prefixLength (for example, 320:320:524/36)
where:
Chapter 2: N Commands
73