Table of Contents
Advertisement
JunosE 11.3.x Command Reference Guide N to Z
route-map
Syntax
Release Information
Description
Options
Mode
402
Specifying a route map for DVMRP or RIP:
[ no ] route-map mapTag [ interfaceType interfaceSpecifier ]
Defining a route map:
[ no ] route-map mapTag [ permit | deny ] [ sequence ]
Defining a route map for data MDTs:
route-map routeMapName
no route-map
Command introduced before JunosE Release 7.1.0.
IP PIM Data MDT Configuration mode added in JunosE Release 8.2.0.
Specifies a route map for DVMRP, RIP, or data MDTs, or defines the conditions for applying
routing policies to filter or modify routes redistributed into or propagated by a routing
protocol. The no version deletes the route map.
mapTag—String of up to 32 alphanumeric characters.
interfaceType—Interface type; see Interface Types and Specifiers on page 5
interfaceSpecifier—Particular interface; format varies according to interface type; see
Interface Types and Specifiers on page 5
mapTag—String of up to 32 alphanumeric characters. The redistribute Router
Configuration command uses this string to reference this route map. Multiple route
maps may share the same map tag.
permit—If the match criteria are met for this route map and permit is specified, the
route is redistributed as controlled by the set actions.
deny—If the match criteria are met for the route map and deny is specified, the route
is not redistributed, and no further route maps sharing the same map tag are examined.
sequence—Number, in the range 0–65535, that indicates the position a new route map
is to have in the list of route maps already configured with the same map tag. If given
with the no version of this command, it specifies the position of the route map that
should be deleted.
Address Family Configuration (RIP), Global Configuration, IP PIM Data MDT Configuration
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
