Path Ds3 Mdl Transmit - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide N to Z

path ds3 mdl transmit

Syntax
Release Information
Description
Options
Mode
160
[ no ] path pathChannel ds3 ds3Channel mdl transmit
{ path-id | idle-signal | test-signal }
Command introduced before JunosE Release 7.1.0.
Enables you to transmit an MDL message on a DS3 signal. This command applies to a
DS3 over channelized SONET interface. The no version disables transmission of the
specified message or all messages.
pathChannel—Number, in the range 1–2147483648, that identifies the path
ds3Channel—Number, in the range 1–3, that identifies the path
path-id—Transmits a path identification message every second; default value is disabled
idle-signal—Transmits an idle signal message every second; default value is disabled
test-signal—Transmits a test signal message every second; default value is disabled
Controller Configuration
Copyright © 2010, Juniper Networks, Inc.