JunosE 11.3.x Command Reference Guide N to Z
set extcommunity
Syntax
Release Information
Description
Options
Mode
494
set extcommunity
{ rt extCommValue [ extCommValue ]* [ additive ] } | { soo extCommValue }
no set extcommunity
Command introduced before JunosE Release 7.1.0.
Sets the BGP extended communities attribute. The no version removes the set clause
from a route map.
rt—Specifies a route-target extended community, which consists of one or more routers
that can receive a set of routes advertised by BGP that carry the extended-community
attribute
soo—Specifies a site-of-origin extended community, which consists of one or more
routers that inject into BGP a set of routes that carry the extended-community attribute
extCommValue—Number identifying the extended community in one of the following
formats:
AS:nn—Autonomous system number, in the range 1–65535, followed by an integer
in the range 1–4294967295; for example, 320:72358
AS:nn—Autonomous system number, in the range 1–4294967295 followed by an
integer in the range 1–65535; for example, 84511:45
ipAddress:nn—Dotted decimal IP address followed by an integer in the range 1–65535;
for example, 10.10.21.5:1256
*—Indicates that one or more parameters can be repeated multiple times in a list in
the command line
additive—Adds the specified extended communities to any previously configured for
the attribute; if omitted, the specified extended communities replace any previously
configured for the attribute
Route Map Configuration
Copyright © 2010, Juniper Networks, Inc.