Path Ds1|E1 Snmp Trap Link-Status - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

path ds1|e1 snmp trap link-status

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
[ no ] path pathChannel { ds1 | e1 } tributaryIdentifier snmp trap link-status
Command introduced before JunosE Release 7.1.0.
Enables SNMP link status processing for DS1 or E1 over channelized SONET and SDH
interfaces. The no version disables SNMP link status processing.
pathChannel—Number, in the range 1–2147483648, that identifies the path
tributaryIdentifier—Specifier for the tributary in the format
pathChannel { ds1 | e1 } pathPayload/tributaryGroup/tributaryNumber
pathPayload—Payload number for the path; value is 1 for SONET and in the range
1–3 for SDH
tributaryGroup—Number, in the range 1–7, that identifies the group within the path
tributaryNumber—Number of the tributary within the tributary group; the value is in
the range 1–4 if the tributary type is vt15 or tu11 and in the range 1–3 if the tributary
type is tu12
Controller Configuration
Chapter 4: P Commands
145