Peer Ip Identity - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide N to Z

peer ip identity

Syntax
Release Information
Description
Options
Mode
186
peer ip identity
{ address ipAddress | range ipRangeLow ipRangeHigh | subnet netAddress netMask }
no peer ip identity
Command introduced in JunosE Release 7.3.0.
Overrides the peer identity (phase 2 identity) used for IPSec security association
negotiations. For IPSec negotiations to succeed, the local and peer identities at one end
of the tunnel must match the peer and local identities at the other end (respectively).
The no version restores the default value, the internal IP address allocated for the
subscriber.
ipAddress—IP address used as the peer identity for IPSec security association
negotiations
ipRangeLow—Low end of a range used as the peer identity for IPSec security association
negotiations
ipRangeHigh—High end of a range used as the peer identity for IPSec security association
negotiations
netAddress—IP network address used as the peer identity for IPSec security association
negotiations
netMask—IP network mask used as the peer identity for IPSec security association
negotiations
IPSec Tunnel Profile Configuration
Copyright © 2010, Juniper Networks, Inc.