Pppoe Clear Lockout Interface - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide N to Z

pppoe clear lockout interface

Syntax
Release Information
Description
Options
Mode
244
pppoe clear lockout interface interfaceType interfaceSpecifier macAddress
Command introduced in JunosE Release 7.2.0.
In configurations with dynamic PPPoE subinterfaces over static PPPoE major interfaces,
clears the lockout condition configured for the individual PPPoE client associated with
the specified source media access control (MAC) address.
There is no no version.
interfaceType—One of the following interface types listed in "Interface Types and
Specifiers" on page 5:
atm
fastEthernet
gigabitEthernet
lag
serial—PPPoE is not currently supported on serial interfaces
tenGigabitEthernet
interfaceSpecifier—Particular interface; format varies according to interface type; see
Interface Types and Specifiers on page 5
macAddress—Source MAC address of the PPPoE client; a unique 48-bit (6-byte)
number that is programmed into each LAN network interface card (NIC) at the time
of manufacture; also known as a hardware address or physical address. The MAC
address format is a dotted triple of four-digit hexadecimal numbers; for example,
0090.1a40.4c7c
Privileged Exec
Copyright © 2010, Juniper Networks, Inc.