Neighbor Distribute-List - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

neighbor distribute-list

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
neighbor { ipAddress | ipv6Address | peerGroupName } distribute-list
accessListName { in | out }
no neighbor { ipAddress | ipv6Address | peerGroupName } distribute-list
[ accessListName ] { in | out }
Command introduced before JunosE Release 7.1.0.
ipv6Address variable added in JunosE Release 8.0.0.
Distributes BGP neighbor information as specified in an access list. The no version removes
an entry.
Using distribute lists is one of several ways to filter BGP advertisements. You can also
use route maps or use AS-path filters, as with the ip as-path access-list Global
Configuration command and the neighbor filter-list command.
ipAddress—IP address of BGP neighbor
ipv6Address—IPv6 address of BGP neighbor
peerGroupName—Name of a BGP peer group. If you specify a BGP peer group by using
the peerGroupName argument, all the members of the peer group inherit the
characteristic configured with this command, unless it is overridden for a specific peer.
accessListName—String of up to 32 alphanumeric characters identifying an access list
in—Applies list to incoming routes (inbound policy)
out—Applies list to outgoing routes (outbound policy); you cannot configure a member
of a peer group to override the inherited peer group characteristic for outbound policy
Address Family Configuration, Router Configuration
Chapter 2: N Commands
35