Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual page 758

Software for e series broadband services routers command reference n to z
Table of Contents

Advertisement

JunosE 11.3.x Command Reference Guide N to Z
716
rtfPrefix—Prefix representing the route-target membership NLRI (RT-MEM-NLRI), in
the format asNumber:extendedCommunity/prefixLength (for example, 320:320:524/36)
where:
asNumber—AS number for origin of route target information, in the range
1–4294967295
extendedCommunity—Two-part number in the format number1:number2 that identifies
an extended community of VPNs, in the format number1:number2, where:
number1—Autonomous system (AS) number, in the range 1–4294967295, or an
IP address
number2—Unique integer, in the range 1–4294967295; 32 bits if number1 is a 16-bit
AS number; 16 bits if number1 is an IP address or a 32-bit AS number
prefixLength—Number that specifies the length of the route prefix, in the range 32–96
fields—Displays only the specified fields; the display order of the fields is hard-coded
and not affected by the order in which you enter them
fieldOptions—Fields to be displayed, in the format
all | [ afi | aggregator | as-path | atomic-aggregate | best | clusters | communities |
extended-communities | imported | intro | in-label | loc-pref | med | next-hop |
next-hop-cost | origin | originator-id | out-label | peer | peer-type | rd | safi | stale |
unknown-types | weight ]*
all—All available information; not recommended, because this information for each
network does not fit on a single line and is difficult to read
afi—Address family identifier
aggregator—AS number and IP address of aggregator
as-path—AS path through which this route bas been advertised
atomic-aggregate—Whether the atomic aggregate attribute is present
best—Whether this is the best route for the prefix
clusters—List of cluster IDs through which the route has been advertised
communities—Community number associated with the route
extended-communities—Extended community
imported—Whether the route was imported
intro—Introductory information about the state of various BGP attributes; this
information is displayed only if you specify this keyword
in-label—MPLS label for the route; the label received with incoming MPLS frames;
typically, but not always, this is the label advertised to MP-BGP peers
loc-pref—Local preference for the route
Copyright © 2010, Juniper Networks, Inc.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.3

Table of Contents