Updating Your Host Set-Up - Juniper SECURITY THREAT RESPONSE MANAGER 2008.2 R2 - LOG MANAGEMENT ADMINISTRATION GUIDE REV 1 Administration Manual

38 S U STRM L
ETTING P
Step 8
Step 9
Updating Your Host
Set-up
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Step 7
M
OG ANAGEMENT
Click Apply Access Controls.
Wait for the interface to refresh before continuing.
You can use the web-based system administration interface to configure the mail
server you wish STRM Log Management to use, the global password for STRM
Log Management configuration, and the IP address for the STRM Log
Management Console:
To configure your host set-up:
In the Administration Console, click the System Configuration tab.
The System Configuration panel appears.
Click the System Management icon.
The System Management window appears.
For the host you wish to update your host set-up, click Manage System.
Log-in to the System Administration interface. The default is:
Username: root
Password: <your root password>
Note: The username and password are case sensitive.
From the menu, select Managed Host Config > STRM Log Management Setup.
The STRM Log Management Setup window appears.
You must enable communications between the STRM Log Management Console
and the current host. In the Enter the IP address of the STRM Log Management
console field, enter the IP address of the managed host operating the STRM Log
Management Console.
In the Mail Server field, specify the address for the mail server you wish STRM
Log Management to use. STRM Log Management uses this mail server to
STRM Log Management Administration Guide