Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual page 521

Mode
Copyright © 2010, Juniper Networks, Inc.
circuit-ID-only—Specifies circuit ID suboption (suboption 1) only
remote-ID-only—Specifies remote-ID suboption (suboption 2) only
inhibit-access-route-creation—Specifies that host routes are not installed; enforces
consistent state of route/client database
In relay mode, removes all installed host routes from IP; deletes all host routes data
in the routing table and NVS; stops accumulating host route information
In relay proxy mode, removes all installed host routes from IP; deletes all NVS client
data and stops installing host routes for newly bound clients in IP; preserves the
routing table client data and continues preservation of newly bound clients in the
routing table
discard-access-routes—Removes existing access routes from the routing table and
from NVS
all—Removes all existing access routes
interfaceType—Interface type whose access routes should be discarded; see Interface
Types and Specifiers on page 5
interfaceSpecifier—Particular interface; format varies according to interface type; see
Interface Types and Specifiers on page 5
unknown—Removes existing host routes from unknown (nonexistent)
interfaces—dynamic interfaces for which DHCP relay retains route information after
these interfaces have been deleted
Global Configuration
Chapter 7: S Commands
479