Query-Interval - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

query-interval

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
query-interval queryTime
no query-interval
Command introduced before JunosE Release 7.1.0.
Specifies how often the router sends PIM router query messages to remote neighbors.
The no version specifies the default time interval, 30 seconds.
NOTE: This command is typically used when you configure PIM remote
neighbors to run multicast services over BGP/MPLS VPNs. That functionality
is no longer supported.
queryTime—Interval, in the range 0–210 seconds, at which the router sends PIM router
query messages from this interface
Interface Configuration
Chapter 5: Q Commands
303