Nsf T1 - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

nsf t1

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
[ no ] nsf t1 { interval [ seconds ] | retry-times [ number ] }
Command introduced before JunosE Release 7.1.0.
Specifies either the interval, in seconds, between IS-IS restart requests sent by a restarting
router on a particular interface to neighboring IS-IS routers in the network, or the number
of times the restarting router resends unacknowledged restart requests on this interface
at the specified interval. The no version restores the default time interval, 5 seconds, or
the default number of retry attempts, 1.
seconds—Time interval in the range 5–120 seconds between transmission of IS-IS
restart requests; default value is 5 seconds
number—Number of times in the range 1–3 that the router tries to resend
unacknowledged restart requests; default value is 1
Router Configuration
Chapter 2: N Commands
93