JunosE 11.3.x Command Reference Guide N to Z
set-overload-bit
Syntax
Release Information
Description
Options
Mode
506
[ no ] set-overload-bit [ on-startup seconds | on-startup wait-for-bgp
[ bgpSeconds ] ]
Command introduced before JunosE Release 7.1.0.
Sets the overload bit, indicating to other IS-IS routers not to use this router as an
intermediate hop in their SPF calculations. The no version restores the default value,
clearing the overload bit.
on-startup—Sets the overload bit only after a system reload; prevents other routers
from routing through this router before it is fully operational
seconds—Period after the reload during which the overload bit is set, in the range
5–86400 seconds; the overload bit is cleared when the period expires
wait-for-bgp—Specifies that the overload bit is not cleared until BGP has completed
convergence
bgpSeconds—Maximum period to wait for BGP to converge, in the range 5–86400
seconds with a default value of 600 seconds; the overload bit is cleared when the
period expires
Router Configuration
Copyright © 2010, Juniper Networks, Inc.