Path Ds3 Equipment Loopback - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

path ds3 equipment loopback

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
path pathChannel ds3 ds3Channel equipment { customer | network } loopback
no path pathChannel ds3 ds3Channel equipment
Command introduced before JunosE Release 7.1.0.
Enables or disables the router's ability to be placed in loopback by a remote device
connected at the DS3 layer for a DS3 signal. This command applies to a DS3 over
channelized SONET interface. The no version restores the default behavior, which disables
the router's ability to be placed in loopback by a remote device. Using the no version has
the same effect as issuing the command with the network keyword.
pathChannel—Number, in the range 1–2147483648, that identifies the path
ds3Channel—Number, in the range 1–3, that identifies the path
customer—Enables the router to start loopback testing when it receives an appropriate
signal from the remote interface
network—Disables the router's ability to start loopback testing when it receives an
appropriate signal from the remote interface; this is the default behavior
Controller Configuration
Chapter 4: P Commands
155