Path Ds3 Clock Source - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

path ds3 clock source

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
path pathChannel ds3 ds3Channel clock source { line | internal
{ module | chassis } }
no path pathChannel ds3 ds3Channel clock source
Command introduced before JunosE Release 7.1.0.
Configures the transmit clock source for a DS3 signal. This command applies to a DS3
over channelized SONET interface. The no version restores the default value.
pathChannel—Number, in the range 1–2147483648, that identifies the path
ds3Channel—Number, in the range 1–3, that identifies the path
line—Interface transmits data from a clock recovered from the line's receive data
stream
internal—Interface transmits data using its internal clock. You must specify one of the
following for internal clocking:
module—Internal clock is from the line module itself
chassis—Internal clock is from the configured system clock
Controller Configuration
Chapter 4: P Commands
153