Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual page 561

Chapter 7: S Commands
bytes—Specifies burst size in bytes
simple—Specifies the simple form of shared shaping, which does not manage voice
and video traffic, but shapes data queue rates to the value of the shared rate minus
the combined voice and video traffic rate
auto—Specifies that the router automatically selects the type of shared shaping
depending on the module; compound is selected only for line modules that support it,
and simple is selected for all other line modules; this is the default mode
compound—Specifies the compound form of shared shaping, which actively shapes
voice and video traffic so that the shared rate cannot be exceeded, and shapes data
queue rates to the value of the shared rate minus the combined voice and video traffic
rate; requires special hardware
explicit-constituents—Overrides automatic selection of compound shared-shaping
constituents and enables you to explicitly specify constituents and bandwidth
allocation; generates an error message and has no effect when applied to modules
that do not support compound shared shaping
Mode Scheduler Profile Configuration
Related Configuring Simple Shared Shaping
Documentation
Configuring Implicit Constituents for Simple or Compound Shared Shaping
Configuring Explicit Constituents for Simple or Compound Shared Shaping
Configuring a Basic Parameter Definition for QoS Administrators
Copyright © 2010, Juniper Networks, Inc. 519