Table of Contents
Advertisement
JunosE 11.3.x Command Reference Guide N to Z
path ds3 mdl carrier
Syntax
Release Information
Description
Options
Mode
158
[ no ] path pathChannel ds3 ds3Channel mdl carrier
Command introduced before JunosE Release 7.1.0.
Specifies that a DS3 signal is used in the carrier environment. This command applies to
a DS3 over channelized SONET interface. The no version restores the default situation,
in which an interface does not operate in the carrier environment.
pathChannel—Number, in the range 1–2147483648, that identifies the path
ds3Channel—Number, in the range 1–3, that identifies the path
Controller Configuration
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
