Path Ds3 Bert - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide N to Z

path ds3 bert

Syntax
Release Information
Description
Options
Mode
152
path pathChannel ds3 ds3Channel bert pattern pattern interval time
no path pathChannel ds3 ds3Channel bert
Command introduced before JunosE Release 7.1.0.
Enables bit error rate tests using the specified pattern for a DS3 signal. This command
applies to a DS3 over channelized SONET interface. The no version stops the test that
is running.
pathChannel—Number, in the range 1–2147483648, that identifies the path
ds3Channel—Number, in the range 1–3, that identifies the DS3 channel
pattern—One of the following test patterns:
0s—Repetitive test pattern of all zeros, 00000...
1s—Repetitive test pattern of all ones, 11111...
2^9—Pseudorandom test pattern, 511 bits long
2^11—Pseudorandom test pattern, 2047 bits long
2^15—Pseudorandom test pattern, 32,767 bits long
2^20—Pseudorandom test pattern, 1,048,575 bits long
2^20-QRSS—Pseudorandom QRSS test pattern, 1,048,575 bits long
2^23—Pseudorandom test pattern, 8,388,607 bits long
alt-0-1—Repetitive alternating test pattern of zeros and ones, 01010101...
time—Duration of the test, in the range 1–1440 minutes
Controller Configuration
Copyright © 2010, Juniper Networks, Inc.