Path Ds3 T1 Bert - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide N to Z

path ds3 t1 bert

Syntax
Release Information
Description
Options
Mode
164
path pathChannel ds3 ds3Channel t1 t1Channel bert
pattern pattern interval time [ unframed ]
no path pathChannel ds3 ds3Channel t1 t1Channel bert
Command introduced before JunosE Release 7.1.0.
Enables bit error rate tests using the specified pattern for a T1 channel on a DS3 signal.
This command applies to a T1 channel on a DS3 over channelized SONET interface. The
no version stops the test that is running.
pathChannel—Number, in the range 1–2147483648, that identifies the path
ds3Channel—Number, in the range 1–3, that identifies the DS3 channel
t1Channel—One or more individual T1 channels, ranges of T1 channels, or combination
of individual channels and ranges, in the range 1–28 (no spaces); for example,
3,7-15,19-13,27
pattern—One of the following test patterns:
2^11—Pseudorandom test pattern, 2047 bits long
2^15—Pseudorandom test pattern, 32,767 bits long
2^20-O153—Pseudorandom test pattern, 1,048,575 bits long
time—Duration of the test in the range 1–1440 minutes
unframed—Test bit pattern occupies all bits on the link, overwriting the framing bits.
If you do not specify this keyword, the test bit pattern occupies only T1/E1 payload bits.
Controller Configuration
Copyright © 2010, Juniper Networks, Inc.