Show Ip Bgp Network - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE N TO Z 2010-10-19 Command Reference Manual

show ip bgp network

Syntax
Release Information
Description
Options
Copyright © 2010, Juniper Networks, Inc.
To display information about a prefix configured for all address families or for a specific
address family other than the route-target address family:
show ip bgp [ ipv4 unicast | ipv4 multicast | vpnv4 all | vpnv4 vrf vrfName ]
network [ networkNumber [ [ mask ] networkMask ] ] [ filter ]
To display information about about a prefix configured for the route-target address
family:
show ip bgp route-target signaling network [ rtfPrefix ] [ filter ]
Command introduced before JunosE Release 7.1.0.
route-target signaling keywords and rtMemNlri variable added in JunosE Release 9.0.0.
rtMemNlri variable replaced by rtfPrefix variable in JunosE Release 9.1.0.
Displays information about a potentially originated prefix that was configured with the
network command.
ipv4 unicast—Specifies the IPv4 unicast address family and routing table; the default
option
ipv4 multicast—Specifies the IPv4 multicast address family and routing table
vpnv4 all—Specifies the IPv4 VPN address family and all IPv4 VPN routing and
forwarding instances
vpvn4 vrf vrfName—Specifies the IPv4 VPN address family and only the IPv4 VPN
routing and forwarding instance with the name vrfName
networkNumber—IP address of the network for which you want information displayed;
if no network is specified, the fields are displayed for all networks
networkMask—Address mask to be applied to the network address
route-target signaling—Displays information for only the route-target address family
rtfPrefix—Prefix representing the route-target membership NLRI (RT-MEM-NLRI), in
the format asNumber:extendedCommunity/prefixLength (for example, 320:320:524/36)
where:
asNumber—AS number for origin of route target information, in the range
1–4294967295
extendedCommunity—Two-part number in the format number1:number2 that identifies
an extended community of VPNs, in the format number1:number2, where:
number1—Autonomous system (AS) number, in the range 1–4294967295, or an
IP address
number2—Unique integer, in the range 1–4294967295; 32 bits if number1 is a 16-bit
AS number; 16 bits if number1 is an IP address or a 32-bit AS number
Chapter 7: S Commands
749