Table of Contents
Advertisement
Hardware Reference
C613-03060-00 REV H
3.
To load a file from AT-TFTP Server to the Switch.
On a terminal connected to the master switch controller's RS-232 ASYN0,
type the command:
LOAD METHOD=TFTP FILE=filename SERVER=ipadd DEST=FLASH
where filename is the name of the file to download and ipadd is the IP
address of the PC running AT-TFTP Server.
4.
To save a TFTP Server log.
Select "Save As" from the File menu.
TFTP requests are logged to the AT-TFTP Server main window.
Switch Start-up
This section outlines the log in and start-up procedures for your switch.
Although the switch will perform basic switching operations without being
configured, you will need to go through these log in and start-up procedures if
you wish to configure the switch and access its full layer 3 switching
capabilities.
Before you can log in, the switch's chassis must have at least one power supply
unit, one fan tray, and one switch controller installed.
To log In
To log in you must first connect the master switch controller to a terminal or
PC. This can be done using the switch controller's RS-232 ASYN0. Two
terminal cables suitable for use with ASYN0 are supplied with each chassis.
If two switch controllers are installed, and the switch has not yet been connected to a
power supply, the switch controller in Bay A will assume master controller status. In all
cases the master controller is the controller whose Master LED is lit.
35
Advertisement
Table of Contents
