Ipv6 Nd Reachable-Time - Allied Telesis AT-IX5-28GPX Manual

IP 6 C
V OMMANDS
6 -
IPV ND REACHABLE TIME

ipv6 nd reachable-time

Overview Use this command to specify the reachable time in the router advertisement to be
used for detecting reachability of the IPv6 neighbor.
Use the no variant of this command to reset the value to default.
Syntax
ipv6 nd reachable-time <milliseconds>
no ipv6 nd reachable-time
Default 0 milliseconds
Mode Interface Configuration for a VLAN interface.
Usage This command specifies the reachable time of the current router to be announced
in IPv6 Router Advertisements.
Advertisement flags will not be transmitted unless you have applied the
suppress-ra
Example To set the reachable-time in router advertisements on the VLAN interface vlan4
to be 1800000 milliseconds, enter the following commands:
awplus#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
To reset the reachable-time in router advertisements on the VLAN interface vlan4
to an unspecified reachable-time (0 milliseconds), enter the following commands:
awplus#
awplus(config)#
awplus(config-if)#
Related ipv6 nd suppress-ra
Commands
ipv6 nd prefix
684 Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
Parameter Description
Time period in milliseconds. Valid values are from 1000 to
<milliseconds>
3600000.
Setting this value to 0 indicates an unspecified reachable-time.
command. This instruction is included in the example shown below.
configure terminal
interface vlan4
configure terminal
interface vlan4
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
ipv6 nd reachable-time 1800000
no ipv6 nd suppress-ra
no ipv6 nd reachable-time
ipv6 nd
C613-50057-01 REV A