Ipv6 Nd Reachable-Time - Allied Telesis IE220 Series Manual

IP 6 C
V OMMANDS
6 -
IPV ND REACHABLE TIME

ipv6 nd reachable-time

Overview Use this command to specify the reachable time in the router advertisement to be
used for detecting reachability of the IPv6 neighbor.
Use the no variant of this command to reset the value to default.
Syntax ipv6 nd reachable-time <milliseconds>
no ipv6 nd reachable-time
Default 0 milliseconds
Mode Interface Configuration for a VLAN interface or a local loopback interface.
Usage notes This command specifies the reachable time of the current router to be announced
in IPv6 Router Advertisements.
To enable the transmission of router advertisements, you must apply the no ipv6
nd suppress-ra command. This instruction is included in the example shown
below.
Example To set the reachable-time in router advertisements on the VLAN interface vlan2 to
be 1800000 milliseconds, enter the following commands:
awplus#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
To reset the reachable-time in router advertisements on the VLAN interface vlan2
to an unspecified reachable-time (0 milliseconds), enter the following commands:
awplus#
awplus(config)#
awplus(config-if)#
Related ipv6 nd suppress-ra
commands
ipv6 nd prefix
C613-50644-01 Rev B
Parameter Description
<milliseconds>
Time period in milliseconds. Valid values are from 1000 to
3600000.
Setting this value to 0 indicates an unspecified reachable-time.
configure terminal
interface vlan2
configure terminal
interface vlan2
Command Reference for IE220 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
ipv6 nd reachable-time 1800000
no ipv6 nd suppress-ra
no ipv6 nd reachable-time
923