Ipv6 Nd Ra-Lifetime - Allied Telesis IE340 Series Command Reference Manual

IP 6 C
V OMMANDS
6 -
IPV ND RA LIFETIME

ipv6 nd ra-lifetime

Overview Use this command to specify the time period that this router can usefully act as a
default gateway for the network. Each router advertisement resets this time
period.
Use no parameter with this command to reset the value to default.
Syntax ipv6 nd ra-lifetime <seconds>
no ipv6 nd ra-lifetime
Default 1800 seconds
Mode Interface Configuration for a VLAN interface or a local loopback interface.
Usage notes This command specifies the lifetime of the current router to be announced in IPv6
Router Advertisements.
To enable the transmission of router advertisements, you must apply the no
version of the
below.
Examples To set the advertisement lifetime of 8000 seconds on vlan2, use the following
commands:
awplus#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
To reset the advertisement lifetime to the default on vlan2, use the following
commands:
awplus#
awplus(config)#
awplus(config-if)#
Related ipv6 nd suppress-ra
commands
ipv6 nd prefix
C613-50631-01 Rev A
Parameter Description
<seconds>
Time period in seconds. Valid values are from 0 to 9000.
Note that you should set this time period to a value greater than the
value you have set using the
ipv6 nd suppress-ra
configure terminal
interface vlan2
configure terminal
interface vlan2
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
ipv6 nd ra-interval
command. This step is included in the example
ipv6 nd ra-lifetime 8000
no ipv6 nd suppress-ra
no ipv6 nd ra-lifetime
command.
977