Ipv6 Nd Ra-Lifetime - Allied Telesis AT-IX5-28GPX Manual

IP 6 C
V OMMANDS
6 -
IPV ND RA LIFETIME

ipv6 nd ra-lifetime

Overview Use this command to specify the time period that this router can usefully act as a
default gateway for the network. Each router advertisement resets this time
period.
Use no parameter with this command to reset the value to default.
Syntax
ipv6 nd ra-lifetime <seconds>
no ipv6 nd ra-lifetime
Default 1800 seconds
Mode Interface Configuration for a VLAN interface.
Usage This command specifies the lifetime of the current router to be announced in IPv6
Router Advertisements.
Advertisement flags will not be transmitted unless you have applied the
suppress-ra
Examples To set the advertisement lifetime of 8000 seconds on the VLAN interface vlan4,
use the following commands:
awplus#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
Related ipv6 nd suppress-ra
Commands
ipv6 nd prefix
C613-50057-01 REV A Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
Parameter Description
Time period in seconds. Valid values are from 0 to 9000.
<seconds>
Note that you should set this time period to a value greater than the
value you have set using the
command. This instruction is included in the example shown below.
configure terminal
interface vlan4
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
ipv6 nd ra-interval
ipv6 nd ra-lifetime 8000
no ipv6 nd suppress-ra
command.
ipv6 nd
681