Ipv6 Nd Managed-Config-Flag - Allied Telesis AT-IX5-28GPX Manual

IP 6 C
V OMMANDS
6 - -
IPV ND MANAGED CONFIG FLAG

ipv6 nd managed-config-flag

Overview Use this command to set the managed address configuration flag, contained
within the router advertisement field.
Setting this flag indicates the operation of a stateful autoconfiguration protocol
such as DHCPv6 for address autoconfiguration, and that address information (i.e.
the network prefix) and other (non-address) information can be requested from
the device.
An unset flag enables hosts receiving the advertisements to use a stateless
autoconfiguration mechanism to establish their IPv6 addresses. The default is flag
unset.
Use the no variant of this command to reset this command to its default of, flag
unset.
Syntax
ipv6 nd managed-config-flag
no ipv6 nd managed-config-flag
Default Unset
Mode Interface Configuration for a VLAN interface.
Usage Advertisement flags will not be transmitted unless you have applied the
suppress-ra
Example To set the managed address configuration flag on the VLAN interface vlan2, use
the following commands:
awplus#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
Related ipv6 nd suppress-ra
Commands
ipv6 nd prefix
ipv6 nd other-config-flag
C613-50057-01 REV A Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
command. This step is included in the example below.
configure terminal
interface vlan2
ipv6 nd managed-config-flag
no ipv6 nd suppress-ra
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
ipv6 nd
675