Ipv6 Nd Managed-Config-Flag - Allied Telesis IE340 Series Command Reference Manual

IP 6 C
V OMMANDS
6 - -
IPV ND MANAGED CONFIG FLAG

ipv6 nd managed-config-flag

Overview Use this command to set the managed address configuration flag, contained
within the router advertisement field.
Setting this flag indicates the operation of a stateful autoconfiguration protocol
such as DHCPv6 for address autoconfiguration, and that address information (i.e.
the network prefix) and other (non-address) information can be requested from
the device.
An unset flag enables hosts receiving the advertisements to use a stateless
autoconfiguration mechanism to establish their IPv6 addresses. The default is flag
unset.
Use the no variant of this command to reset this command to its default of having
the flag unset.
ipv6 nd managed-config-flag
Syntax
no ipv6 nd managed-config-flag
Default Unset
Mode Interface Configuration for a VLAN interface or a local loopback interface.
Usage notes To enable the transmission of router advertisements, you must apply the no
version of the
below.
Example To set the managed address configuration flag on vlan2, use the following
commands:
awplus#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
Related ipv6 nd suppress-ra
commands
ipv6 nd prefix
ipv6 nd other-config-flag
C613-50631-01 Rev A
ipv6 nd suppress-ra
configure terminal
interface vlan2
ipv6 nd managed-config-flag
no ipv6 nd suppress-ra
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
command. This step is included in the example
971