Ipv6 Nd Managed-Config-Flag - Allied Telesis x510-28GTX Command Reference Manual

IP 6 C
V OMMANDS
6 - -
IPV ND MANAGED CONFIG FLAG

ipv6 nd managed-config-flag

Overview Use this command to set the managed address configuration flag, contained
within the router advertisement field.
Setting this flag indicates the operation of a stateful autoconfiguration protocol
such as DHCPv6 for address autoconfiguration, and that address information (i.e.
the network prefix) and other (non-address) information can be requested from
the device.
An unset flag enables hosts receiving the advertisements to use a stateless
autoconfiguration mechanism to establish their IPv6 addresses. The default is flag
unset.
Use the no variant of this command to reset this command to its default of, flag
unset.
ipv6 nd managed-config-flag
Syntax
no ipv6 nd managed-config-flag
Default Unset
Mode Interface Configuration for a VLAN interface.
Usage Advertisement flags will not be transmitted unless you have applied the
suppress-ra
To set the managed address configuration flag on the VLAN interface vlan2, use
Example
the following commands:
awplus#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
Related ipv6 nd suppress-ra
Commands
ipv6 nd prefix
ipv6 nd other-config-flag
C613-50170-01 Rev B
command. This step is included in the example below.
configure terminal
interface vlan2
ipv6 nd managed-config-flag
no ipv6 nd suppress-ra
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
ipv6 nd
850