Show Loop-Protection - Allied Telesis AT-IX5-28GPX Manual

S C
WITCHING OMMANDS
-
SHOW LOOP PROTECTION

show loop-protection

Overview Use this command to display the current loop protection setup for the device.
Syntax
show loop-protection [interface <port-list>] [counters]
Mode User Exec and Privileged Exec
Usage This command is used to display the current configuration and operation of the
Loop Protection feature
Examples To display the current configuration status for port1.0.1, use the command:
awplus#
Figure 10-4: Example output from the show loop-protection command
To display the counter information for port1.0.1, use the command:
awplus#
C613-50057-01 REV A Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
Parameter Description
The interface selected for display.
interface
A port, a port range, or an aggregated link.
<port-list>
Displays counter information for loop protection.
counters
show loop-protection interface port1.0.1
Loop-Detection:
LDF Interval:
Interface:
Action:
Timeout:
Vlan:
Status:
Timeout Remaining:
Vlan:
Status:
Timeout Remaining:
show loop-protection interface port1.0.1 counters
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
Enabled
10 [sec]
port1.0.1
port-disable
300 [sec]
1
Blocking
115 [sec]
2
Normal
0 [sec]
385